ASTM D7518-20(2026)

Current Revision
Standard Specification for 1,3 Propanediol (PDO) Base Engine Coolant for Automobile and Light-Duty Service

Best Price Guarantee Aug 1, 2026 English 5 Pages

Sub Total (1 Item(s)) $ 0.00
Estimated Shipping $ 0.00
Total (Pre-Tax) $ 0.00

You own the digital copy of this edition

View in Library
or
ASTM International Logo

ASTM D7518-20(2026)

Standard Specification for 1,3 Propanediol (PDO) Base Engine Coolant for Automobile and Light-Duty Service

PUBLISH DATE 2026
PAGES 5
ASTM D7518-20(2026)

This specification covers the requirements for *propanediol base engine coolant* used in automobiles or other light-duty service cooling systems.

Engine coolant concentrates or prediluted propanediol base engine coolant shall be formulated with propanediol, water, suitable corrosion inhibitors, dye, and a foam suppressor. The coolants shall conform to the general requirements for color and effect on nonmetals.

Coolants shall be formulated using water that meets the requirements for the following properties:

  • chlorides
  • sulfate
  • hardness
  • pH
  • iron

Glycol-base coolant concentrates and prediluted coolants shall conform to the following physical and chemical requirements for each coolant type:

  • relative density
  • freezing point
  • boiling point
  • ash content
  • pH
  • chloride
  • water mass
  • reserve alkalinity
  • effects on automobile finish

All coolant concentrates and prediluted coolants shall conform to the performance requirements such as:

  • corrosion in glassware
  • simulated service test
  • corrosion of cast aluminum alloys at heat-rejecting surfaces
  • foaming
  • cavitation-erosion

1.1Β This specification covers the requirements for 1,3 propanediol base engine coolants used in automobiles or other light-duty service cooling systems. When concentrates are used at 40 % to 70 % concentration by volume in water, or when prediluted glycol base engine coolants (50 volume % minimum) are used without further dilution, they will function effectively to provide protection against freezing, boiling, and corrosion.

1.2Β The coolants governed by this specification are categorized as follows:

Coolant Type

Description

I

1,3 propanediol base concentrate

II

1,3 propanediol predilute (50 vol %)

Note 1:Β This specification is based on the knowledge of the performance of engine coolants prepared from new or virgin ingredients.

Note 2:Β This specification applies to automobiles and light-duty service. A specification for heavy-duty engine service is under development.

1.3Β The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.4Β This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5Β This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Loading...

Failed to load document history.

Publish Date Document Id Type View