Logo
Login Sign Up
Current Revision

ASTM F480-25

Standard Specification for Thermoplastic Well Casing Pipe and Couplings Made in Standard Dimension Ratios (SDR), SCH 40 and SCH 80
Best Price Guarantee
Instant
2-5 Days
SAVE 10%

$104.00

$104.00

$187.20

$125.00

$125.00

$225.00



Sub Total (1 Item(s))

$ 0.00

Estimated Shipping

$ 0.00

Total (Pre-Tax)

$ 0.00


View in Library
or
ASTM International Logo

ASTM F480-25

Standard Specification for Thermoplastic Well Casing Pipe and Couplings Made in Standard Dimension Ratios (SDR), SCH 40 and SCH 80

PUBLISH DATE 2025
PAGES 26
ASTM F480-25

This specification covers water well casing pipe and couplings made from **thermoplastic materials** in standard dimension ratios (SDR), SCH 40, and SCH 80.

Well casing is produced in either *plain end*, *belled end*, or *threaded*, and is used for water wells, groundwater monitoring, leak detection, recovery systems, dewatering systems, and waste disposal.

The following shall be tested to meet the requirements prescribed:

  • Well casing pipes
  • Well casing pipe couplings
  • Pipe stiffness and flattening
  • Impact resistance
  • Tup puncture resistance
  • Thread and threaded joints
  • Joint strength
  • Well screens

1.1 This specification covers water well casing pipe and couplings made from thermoplastic materials in standard dimension ratios (SDR), SCH 40 and SCH 80.

1.2 Specifications are provided for the application of these materials to water well and ground water monitoring applications. Flush threaded joint systems are included for screen and casing used primarily in the construction of ground water monitoring wells (see Practice D5092/D5092M).

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. (See IEEE/ASTM SI 10.)

Note 1: Certain field conditions may require alternative materials to ensure safe long-term use. The user should consult federal, state, and local codes governing the use of thermoplastic materials for well casing or monitor pipe.

Note 2: This standard specifies dimensional, performance and test requirements for plumbing and fluid handling applications, but does not address venting of combustion gases.

1.4 Although the pipe sizes and SDR values listed in this specification are generally available, numerous other plastic pipes in Schedule 40 and 80 wall, other SDR values and various outside diameters have been used for well casing. Such products are often selected because they fulfill certain needs and Annex A1 includes a list of these Plastic Pipe Well Casing Specials.

1.5 The following safety hazards caveat pertains only to the test method portion, Section 6, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

SDO ASTM: ASTM International
Document Number F480
Publication Date Dec. 1, 2025
Language en - English
Page Count 26
Revision Level 25
Supercedes
Committee F17.61
Loading...

Failed to load document history.

Publish Date Document Id Type View