Paper and board - Determination of tensile properties - Part 3: Constant rate of elongation method (100 mm/min)

Rubber compounding ingredients - Silica - Oil absorption of precipitated silica

Water quality - Detection of Salmonella spp.

Plastics - Determination of scratch properties

Soil quality - Simultaneous determination of multi-class pesticide residues in soil using gas chromatography-tandem mass spectrometry (GC-MS/MS) and liquid chromatography-tandem mass spectrometry (LC-MS/MS) analysis

Soil quality - Guidance on the determination of background values

Plain bearings - Bearings with embedded solid lubricants

Photography - Archiving Systems - Vocabulary

Photography - Archiving systems - Imaging systems quality analysis - Part 1: Reflective originals

Monolithic (unshaped) refractory products - Part 1: Introduction and classification

Low alloyed steel - Determination of C, Si, Mn, P, S, Cr, Ni, Al, Ti and Cu - Glow discharge optical emission spectrometry (routine method)

Monolithic (unshaped) refractory products - Part 2: Sampling for testing

Monolithic (unshaped) refractory products - Part 3: Characterization as received

Monolithic (unshaped) refractory products - Part 4: Determination of consistency of castables

Monolithic (unshaped) refractory products - Part 5: Preparation and treatment of test pieces

Monolithic (unshaped) refractory products - Part 6: Measurement of physical properties

Petroleum, petrochemical and natural gas industries - Qualification testing and acceptance criteria for protective coating systems under insulation

Monolithic (unshaped) refractory products - Part 7: Tests on pre-formed shapes

Monolithic (unshaped) refractory products - Part 8: Determination of complementary properties

Coal and coke - Determination of gross calorific value

Corrosion of metals and alloys - Measurement of critical crevice temperature for cylindrical crevice geometries in ferric chloride solution

Air cargo - Fire-resistant containers - Design, performance and testing requirements

Condition monitoring and diagnostics of machines - Hydroelectric generating units

Non-destructive testing of welds - Phased array ultrasonic testing (PAUT) - Acceptance levels

Welding consumables - Solid wire electrodes, solid wires and rods for fusion welding of magnesium and magnesium alloys - Classification